Nozzle leaking melted raw material is common problem during cable ties injection moulding.
- If the springs Nozzle always break . Please check the material burn or not. If material burn, need to take the material out.
- Please note that, don’t always stop the machine. As the temperature will be very high when production around 300 degree, if always stop the machine, the material will be very easy to burn, if material burn have to take the material out.
- If always stop the machine when production, temperature much high, then the ties will be very easy to break. You have to put the ties into water to absorb the water then will be better.
- Material leakage, please kindly check is there any material leakage from the machine nozzle area. If have material leakage then will be hard to produce, need to solve this problem first. Please use our spring nozzle for your machine. After solve this material leakage problem then could produce. The spring nozzle picture as below shown.
Any more question on the cable tie moulds, welcome to contact Taizhou Xiongshi Plastic Mould Co., Ltd